LFOTPP Fit for 2PCS 2017 2018 2019 2020-2024 Chrysler Pacifica 10 Inch Rear Seat TV Glass Screen Protector,Back Seat Entertainment Headrest TV Screen Protector 9H Hardness Tempered Glass Anti Scratch

I purchased the pair for the rear screen as well as the one for the front screen.The cover was very tight from top to bottom on my rear right screen. The first protector was so tight that I actually broke it while trying to maneuver into position. My second try was also tight but I managed to finesse it in. I contacted the company and they sent me a new pair free of charge. I then installed one on the left rear screen and had no difficulties at all. I’m not sure if the better fit was due to variations in Chrysler or in this product.I wish the front protector were a few millimeters wider and longer, and the corners not so rounded. There’s still a fair bit of exposed screen around the edges. Because of this, it’s very obvious that there’s a screen protector on the screen.Besides the good customer service, I liked how well these installed. I managed to install all three without any bubbles or lint trapped beneath the cover. That’s a first for me. Maybe just experience after doing it so many times. My techniques was- Wipe the screen down with the alcohol pad and use the dust stickers to remove ever last trace of lint- Wipe down both sides of the screen protector to remove lint. I think this is key, because sometimes static electricity will pull lint onto the adhesive as you pull off the backing.- I’m right-handed and started by aligning the left edge of the protector on the screen, holding the right edge just a quarter inch above the screen with my right hand. Make sure the edges are perfectly parallel- Lightly press down the protector’s left edge, swiping your left finger up and down. Continue to swipe up and down as you slowly move it towards the right. Slowly bring the right edge closer to the screen as you go to relieve tension.- I you go too fast you might trap an air bubble as you’re going. Don’t panic. With your right hand still on the right side of the protector, carefully pull it back from the screen until the bubble is released. If you’re doing everything right, you will see a “wetted” edge slowly advanced from left to right.- When you get most of the screen down, you may need to let go of your right hand to relieve tension. That’s okay. Continue to swipe your left finger up and down, slowly moving to the right.- If you find any bubbles, don’t panic. You can probably still remove them by carefully swiping back and forth on one side of the bubble until it reaches the edge.Hope this helps. [...]